To create a monitoring user account
Configuration details to specify when adding the asset to Entuity
Entuity supports hardware monitoring on Fujitsu Primergy M2 and above servers with an Integrated Remote Management Controller (iRMC) version of S4 or higher through the embedded Redfish REST API. Entuity discovers the enclosure, blades, processors, fans, memory modules, physical disks, disk controllers, logical disks, power supplies, ports, and sensors for each system. To do so, the Entuity collector uses port 443 (which must be open bidirectionally between the Entuity server/agent and the system) and a monitoring user account.
Supported devices
-
Fujitsu Primergy RX Series, TX Series, CX Series, and BX Series servers using iRMC S4 and above
To create a monitoring user account:
For iRMC version S4:
1. Log into the iRMC management interface with administrator-level credentials from the web UI.
2. Navigate to User Management > iRMC S4 User > New User.
3. Enter a username, password, and password confirmation for the user account.
4. Ensure the Enable User check box is selected and optionally enter a description for the user
account.
5. Ensure the Redfish Enabled check box is selected.
6. Change the RedfishRole to "ReadOnly".
7. Click Apply to save your changes.
For iRMC version S5:
- Log into the iRMC management interface with administrator-level credentials from the web UI.
- Navigate to Settings > User Management > iRMC Local User Accounts.
- Click Add, and then enter a username, a password, and the password confirmation on the User Information screen.
- Ensure the Enable User check box is selected and optionally enter a description for the user account.
- From the Access Configuration tab, ensure the Enable Redfish/Web UI User check box is selected and then choose Read Only as the Redfish Role.
- Click OK to save your changes.
Configuration details to specify when adding the asset to Entuity
When you add the server to Entuity from the Asset Management page, specify the following information on the Add Asset form:
- In the Management Level section, select Server from the Asset Category drop-down field, and Fujitsu Primergy from the Asset Type drop-down field.
- In the Asset Details section, enter the system IP address in the Polled Name/IP Address field.
- In the Hardware Monitoring section, select Fujitsu Primergy (REST) from the Connection Method drop-down field.
- On the Credential form (accessed by clicking the Credential field in the Hardware Monitoring section), enter the newly created user account name and password in the appropriate fields.
Comments
0 comments
Please sign in to leave a comment.